SAAC Forum

That would be great.  I will send you a PM.

I need just the lower rear seat upholstery for a 67 fastback with deluxe interior.  Need it for a pattern.  My upholstery shop is making a complete set of covers using NOS materials but the lower seat cover was out of a standard interior.  Condition not too important as long as we can get measurements off it.   

Here is a picture of the lower leaf from a 67 Shelby GT350 we are restoring.  Built 05/02/67.  This is after the springs were de-rusted with Rust911..

Looking for a nice 68 fastback rear seat bottom for deluxe comfort weave interior.  Working on a car that someone switched out the rear seat bottom with one out of a 65.  The rest of the interior in super nice so trying to match up a nice used one.   

Are you sure about that number?   According to the 3M Website 5887 is "a flexible two part epoxy material designed for use in the repair of flexible and semi-rigid plastic parts".

Thanks JD.  Figured it was not so I went ahead and ordered it.  Can't be too choosy with these parts!

Found the fan.  It was listed on eBay for a six cylinder Fairlane but had the correct codes on it.  Also found a spacer but the logo on the front is bad so would like to find a better one.

Wanted for a 67 GT350 without AC.  Need a cooling fan with part number C6OZ-8600-D marked C6OE-D and a spacer part number C4AZ-8546-F (YA-74).  Not sure of the marking if any.  I know the spacer has a Motocraft replacement with the same part number unfortunately they have a casting of C8AE-E which would not have been found on a 1967 car.

Bump

Still need one of these!

Thank you.  I noticed Branda says not all 68 Shelby's came with these.  When the body shop took the car apart they said there was none there so maybe they were right.  The holes for the screws that hold them in place are there however.

oes anybody reproduce these hole covers that screw onto the steel tail panel?  If not does anyone have a complete set?

Does anybody reproduce these hole covers that screw onto the steel tail panel?  If not does anyone have a complete set?

Dave - I am still on the hunt for the torsion bar also.  Need one without any pitting.  Let me know if you find a spare.

John Benoit

There was an article in Mustang and Fords by Bob Perkins.  This is the paint he said was correct.