SAAC Forum

Thank you Bob. I looked closer at the dirty one that I took pictures of.  Of course you are right and it is necked down. Same diameter as the one in the car. Now just to figure out which one is the right one for the car. Where on the housing would I find the silk screen? What about the rear axles only having the two recessed holes? Or do I need to look through my stuff to find ones with the three recessed holes? I wish now I had not taken pieces off. I should shoot myself. Thanks again for your help.

PS Any Idea how to get the over spray off without messing up the door tag? I still have to repaint the car. Over spray was done sometime before 1987.

Roger

Congrats on your car. And progress.

I have had my 68 for many years. Not running. Some of you are going to shoot me for this but in the mid 90's. I took some parts off of it for my race car. The race car was at least a 69 Mach 1. I can not remember if I pulled the rear axle housing.
Is it supposed to have necked down axle tubes or straight. Is the straight one in the pics it? I know the axles only have two recessed holes. But they are 31 spline.
I am trying to get it finished in time for this years SAAC meet in Sonoma.

PS How do you remove the over spray on door tag. Without ruining the door tag.

Thanks for the help.

Roger

Does anyone know the length of a Boss 9 upper A-arm? Measured from center of pivot shaft to center of ball joint.

Thanks for the help.

Roger

I am sure hoping for the long course.
Thanks for the response.

Do we get to run the long course or do we going to have to run the NASCAR course?
Looking forward to the show.
Thanks for all the work to get us there.

Roger