SAAC Forum

I have owned my 67 GT500 for many years.  It was built 1/10/67 in San Jose and should have a smog system but does
not.  I'm not sure if it is likely that I could find the parts to assembly one.  i would appreciate any suggestions.

Thanks.

Walt Weems

I'm looking for someone to rebuild/repair the smog pump for my KR.  Anyone know
of someone?

Walt Weems

I am looking for a source for the conv. top got my KR and want to get one as correct as
possible.  Mine has the glass rear window. 

Thanks.

Walt Weems

I have owned my 68 KR conv. w/4 speed for over 20 years.  I have seen different sales numbers like 518,318 etc.  Does anyone know how many were sold?

Thanks,

Walt Weeems

My steering column shakes when I pass over a small bump in the road and I am looking for a quality
shop to rebuild the column.

I have done all the easy stuff like new wheels & radial tires, balancing & alignment, balanced drive shaft, rebuilt steering box, new front springs and I'm out of ideas.  I have owned the car for over 20 years and have taken it to two shops, one a shelby restorer but without a solution.

Thanks.

Walt Weems

Anyone know of a source for rebuilding the steering column?  Can I remove it without removing the engine?

Thanks.

Walt Weems

I'm adjusting the distributor points on my 67 GT500 and seem to remember that .20 is the gap.  Is that correct?

Thanks,

Walt

Anyone know of a good carb repair guy in Mayland/DC/Virginia areas

Walt

I have the original holly 600's and the hot idle is 1000 rpm but cold idle is too low and I want to adjust them higher by turning the screw under the carb counterclockwise but want to know if I should increase both carbs or just one and, if so, which one.

Thanks for the advise.

Wat Weems

I own a 68 GT500KR 4 speed built July 68 and would like to know if the car should have an oil cooler.

Thanks,

Walt Weems

Hi all,
I have replaced my power steering hoses with concourse ones on my 67 GT500 without air and the metal spiral sleeve from the pressure hose rubs the
power steering parts that travel back and forth.  Can anyone send me a picture of how the hose is routed.

Thanks.

Walt Weems

The rear interior panel of my 67 GT500 has been cut for speakers.  This is the piece that has the round interior lights. The cutout is in the rounded area near the door striker.  I want to replace the panels but don't know what they are called or where to get them. Please help with advise.

Walt Weems

I would like to buy an original AM radio for my 67 GT500.  Can anyone please advise me as to what part number to look for?

Thanks,

Walt Weems

Can anyone advise me on a source for front shocks for my 67 GT500.  I want to find ones that are the original type.

Thanks,

Walt Weems

I've owned my 68 KR conv. for 25 years.  It is unrestored and presents very well, but the steering column always shakes at times especially when I hit a very small bump.  I have had sets of new radials, balanced, aligned, replaced front springs, ball joints, rebuilt steering box.  A local mustang restorer tightened the steering box adjustment, but the problem persists.  Have any of you guys experienced this type of problem?  Any thoughts?

Anyone know where the cold idle adjustment id on 67 GT500?