SAAC Forum

Hi. If you need a SCJ crank, I can help. I did the opposite on mine. I used an SCJ shortblock and swap it to CJ. I have now just the crank.Rods, damper and hatchet are sold. PM if interested

Patrick
Quebec, Canada

Funny, sylver jade is not there 🤔

It hold one point of wiper motor bracket behind.

Patrick

Suspect your fan clutch.

Patrick

Quote from: Ldouble619 on May 08, 2022, 08:51:43 AM
Thanks to both!  I those were the two tires I was debating. Mickey Thompson's ST are about the same price as the coopers (3$ more)

Quote from: Ldouble619 on May 08, 2022, 08:52:28 AM

Quote from: Shelbypat on May 07, 2022, 08:55:23 PM
I run 245/60/15 sportman, Mickey Thumpson but 235 is more popular from my observation

Patrick

Thanks, Patrick. Do you have any rubbing with the 245?  Any pics?

No rubbing.
Here a pic.
Stance is not correct as there is no heads on the engine.

Patrick

Tks for clarification. I've been into the myth for decades.

Patrick

First, rod cap is always part of the rod. Main cap is always part of the engine block so no part number for caps.
Second, keep in mind your engine short block has been replaced at Shelby American when your car was brand new from 390 to 428 PI. So block ingenering number would be C6ME or C6ME-A. For late I would say C7ME or C7ME-A.
IMHO

Patrick

I run 245/60/15 sportman, Mickey Thumpson but 235 is more popular from my observation

Patrick

Bulbs with 2 elements. When 1 touch the other one inside, it can cause freegame like you have.

Best of luck
Patrick

So. Originaly the clip is not attach..
Am I right ?

Pattick

Are those round clips availible ?

Quote from: shelbydoug on March 25, 2022, 01:04:36 PM

Quote from: Royce Peterson on March 25, 2022, 12:17:15 PM
It's a big bearing 1969 - 70 drum brake spindle.

Quote from: brandosaac on March 25, 2022, 11:51:39 AM
thanks, 'but do you know what the spindle itself is correct for?

That means it has the big hub also. You could do the "Big Ford" brake swap on those.

No you can use 69 drum spindle to swap to 4 pistons caliper only

Here the place left hook touch. I will replace the left mount and see if I gain gap.
It was not like that when I restaured the car 15 years ago

TKS
Patrick

Hi. I was doing some maintenance on my  Gt 500 and noticed engine oil pan is very close to the cross bar underneath and left lift hook is touching the reinforcing plate of the shock tower
Is engine mounts collapsed a commun  issue ?

TKS
Patrick
 

Assembly manuel show right side and back to left side through inner structure behind trunk lid hinges.

Patrick