SAAC Forum

Hi, I am looking for one ducting piece that is used on the rear brake cooling hose that attaches to the inside of the car.  It looks like the one pictured.  Thanks.

HI, PM sent.

I was reading an old 1997 world registry and noticed that in the Appendix IV-supplementary colors (page 1281) it states that the inside of the brake scoops are semi-gloss black unless it was a green or black car.  Is this correct, restoring a green car.  Thanks

I am looking for the driver side 1966 brake line bracket.  The bracket goes near the front wheel where the metal line meets the rubber.  The attached picture is my passenger side.  Thanks

Thanks Jeff, The passenger side is out of my mid march 66 built Fastback.  It had the fiberglass trunk lid from JC Whittney on it so the bar was removed back in the day.  Both hinges are tight.  If I can make a few bucks and help someone else out, to me that is what this hobby is about.

I have a driver side trunk hinge for a fastback dated 6 11 2D  $15 plus shipping.  I aslo have the passenger side dated 12 2 D. (This side is missing  the factory torsion lever but I have metal to make a replacement), $15 plus shipping.  Also factory trunk torsion bar $5 plus shipping

Thanks for the help!!

Does anyone have a picture of the correct brake Distribution Block, driver side near hood hinge.  My car is a mid March built car.  Thanks

   Yes it is for a 66.  Thanks for the info!!

Which way does the 10 spoke wheel face in the trunk?  Is the outside facing down towards the trunk floor or facing up?  I seen pictures of both but want to know what is correct.  Thanks for your help.

Thanks all for the articles, they are very helpful. 

Thanks for the lead,  sent him an e-mail.

Hi, Want to buy or leads on a 1966 jack. (Found One Local)

Does anyone know this date code?  8606   They are  82-1388 SP3.  I just took them off my 66 Mustang.    Thanks for the help.

I wish I took some of the interior but did not.  It matched the brown, very 60's.