SAAC Forum

Looking for 289 HiPo head C7ZE Non Smog

Thanks

What are the correct fasteners for inboard headlight buckets?

I own an early February GT350 and the car does have inboard lights. My lights have 3/16 x 1/2 hex bolts with lock washers.  Are these the correct fasteners? or is slotted sheet metal screws correct?

Thanks

Looking for the Carter carbs that was sold over the counter on the 289 2X4 Cobra Intake setup by Ford.

Think, correct carbs are Carter's 3258s and 3259S stamped on the right front mounting flanges.  Also, looking for fuel log, chrome air cleaners and linkage..

If anyone has any of these parts or single carb, please send me PM trying to put a setup together for my car. 

I only have the intake @ this point...

Thanks

Looking for the following 67' parts....

- Passenger side hood pin mounting bracket
-  Aluminum Tail Light Trim Ring, early style with screw in studs
- Tail Light Inner steel mounting brackets
- NOS fiberglass quarter panel end caps

Also looking for 1- C7ZE 289 HiPo head in good shape, non-smog..

Thanks, please send me PM....

Looking for the Ford 289 2x4 Holley carbs.  C6OA-A -List 3360 or C6OA-B - List 3361....  Needed a pair or I would also be interested in either one carb singly......


Please send me PM,  Thanks

Looking for 1 or a pair of C7ZE 289 HiPo heads.

Please send me PM,,,  Thanks

This case is the double ribbed case with the C4AW marking.  Also has the filler on the drivers side. 

Pinion support on this case is a Daytona C5AW with built date of B8.  Did these SPEC cases come with a Daytona pinion support or just standard support?

Thanks

Anyone have any pictures of the spec case with it's original pinion support?

Thanks

Question?  Was the 67' Shelby the only Shelby that came with the SPEC center section? and was the SPEC center section only installed in the GT500?

Thanks

Looking for 67' Shelby tail light aluminum S7MS bezels in good shape.  Need the early style with screw in studs. 

Thanks

What's the Ford stamped part number on the 67' fan?

Thanks

JD and Bob, thanks for your responses.  Build date of my car is January and the original tail light panel is the flat style panel.  When I bought this car the original owner gave me pictures of the car when it was new from the dealer and the rear panel was also painted silver instead of color coded to the car.

Thanks

Looking for the following 67' NOS or used parts

- Passenger side hood pin mounting bracket
- Fiberglass rear tail light mounting panel - Flat Style
- Lower grille mesh
- Aluminum Tail Light Trim Rings
- Tail Light Inner steel mounting brackets

Also looking for 1- C7ZE 289 HiPo head in good shape

Thanks