SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.
Its probably been discussed a dozen times on this forum but I'll be darned if i can find a template, dimensions on the hood stripe. Of course this dawned on me as the painter hit me up about it today. HELP! Thanks Dan
Gary the hood stripe drawing measurements are correct its the way u read them and the description in 96 registry the way they were discribed to the left of drawing was wrong as it says 15/16'' but look at drawing as there is a space between the 1 and 5 so it should have read 1 5/16'' NOT 15/16'' and wrong again in 97 registry description to left of drawing reads two stripes are 21 3/16'' apart but drawing is 21 13/16'' apart. Most 70 shelby repainted cars have got this wrong looking at the 97 registry and reading it wrong but i have went over this with saac and vinny is going to have it corrected in new 69-70 shelby registry. This is why unrestored cars are so valuable to document these type of issues and we have 2 70 shelby low mile survivors coming to our 50th 70 shelby show one has 6000 mile and a never shown before 540 mile 70 shelby coming from east and i have documented both of these cars original hood stripes and thats why i am making all 4 new template stencils using my nos RH outer stencil from kk plant to get the curves right and drawings from the inner curves as they are not the same curves around front scoop opening as the inner is a wider curve than the outer curve and if u look at the hood in the front scoop area the inner fiberglass is moulded higher that the outer since hood is arched in that area.