Author Topic: carburetor mounting question  (Read 1825 times)

6T6/7

  • SAAC Member
  • Jr. Member
  • *
    • View Profile
carburetor mounting question
« on: April 10, 2021, 06:23:53 PM »
Did the assembly line installation of the carburetor to intake manifold use anything other than nuts, such a lock washers? Or just nuts only? Think I've seen some variety with this. In particular, I'm looking at a '66 GT350, but thinking this question is more generic in nature, so placed it here.
‘66 6S379, ‘67 GT350 #1661

Royce Peterson

  • Hero Member
  • *****
    • View Profile
Re: carburetor mounting question
« Reply #1 on: April 10, 2021, 06:29:49 PM »
Just the nuts except the driver side rear which has the return spring bracket under the nut. No washers of any kind.
1968 Cougar XR-7 GT-E 427 Side Oiler C6 3.50 Detroit Locker
1968 1/2 Cougar XR-7 428CJ Ram Air C6 3.91 Traction Lock

6T6/7

  • SAAC Member
  • Jr. Member
  • *
    • View Profile
Re: carburetor mounting question
« Reply #2 on: April 10, 2021, 07:38:47 PM »
Thanks Royce
‘66 6S379, ‘67 GT350 #1661