News:

We have implemented a Photo Gallery for hosting images right here on SAACFORUM. Check the How-To in News from HQ

Main Menu

1968 4-speed console

Started by Grouper Trooper, June 12, 2021, 05:12:15 PM

Previous topic - Next topic

Grouper Trooper

Is/was there a chrome finish trim ring (square) attached to the opening in the console where the boot for the shifter comes through?
Jayson Horadam
1968 GT 350 #1516
2 X 4 Holley's sittin' on all SCAT 331
www.mpaenforcement.com

corbins

I believe so... but not really attached as far as I know.

GT350AUS

Yes, it is retained by the lower part of the boot, not screwed to the console

Grouper Trooper

So sandwiched between the console? Shelby specific? Anyone know if they are available? I don't see anything at Branda's.
Jayson Horadam
1968 GT 350 #1516
2 X 4 Holley's sittin' on all SCAT 331
www.mpaenforcement.com

Coralsnake

#4
The square, chrome bezel is not Shelby unique. It is installed on top of the console. It pushes down over the folds of the shifter boot and "floats" in place.


https://store.cobranda.com/19shbore.html
The original Influencer, check out www.thecoralsnake.com

Grouper Trooper

#5
Ok, now I understand! I remember this trim from a 67 Mustang 289/2V 3 speed manual my father had from 1970-76.
Thank you very much for the clarification! I knew the boot floats... now I know how they were "sealing" the inside of the car from the outside.
Jayson Horadam
1968 GT 350 #1516
2 X 4 Holley's sittin' on all SCAT 331
www.mpaenforcement.com

Corey Bowcutt

Not sure what you mean by sealing the inside of the car from the outer but this chrome bezel is not really doing that.  A combination of the lower rubber boot around the shift mechanism and the upper boot do that.

Grouper Trooper

Yes, but I would think the bezel on top would help to keep the boot portion under the console secure to the underside of the console. Or, is it strictly cosmetic?
Jayson Horadam
1968 GT 350 #1516
2 X 4 Holley's sittin' on all SCAT 331
www.mpaenforcement.com

Tired Sheep

Cosmetic

The rubber boots are screwed to the floor

Grouper Trooper

#9
Two years after I thought I had the console properly back together, now I think it probably is thanks to everyone's input. Any exact placement issues on the shift pattern plate or was it centered, toward the driver side? Any instructions for the worker, or was it pretty random?
Jayson Horadam
1968 GT 350 #1516
2 X 4 Holley's sittin' on all SCAT 331
www.mpaenforcement.com

Corey Bowcutt

I am not sure it should even have that shift pattern plate?

Tired Sheep


Grouper Trooper

Thanks, it will be heading to the dark drawer of other useless chotskies.
Jayson Horadam
1968 GT 350 #1516
2 X 4 Holley's sittin' on all SCAT 331
www.mpaenforcement.com