Author Topic: Autolite 4100  (Read 241 times)

C Griffith

  • Newbie
  • *
  • Posts: 5
    • View Profile
Autolite 4100
« on: July 22, 2021, 12:15:47 PM »
Anybody here know how to tighten the accelerator Lever on the accelerator shaft?

Noticed it to be loose and not producing consistent idle readings.

CharlesTurner

  • SAAC Member
  • Hero Member
  • *
  • Posts: 857
    • View Profile
Re: Autolite 4100
« Reply #1 on: July 22, 2021, 01:28:29 PM »
The ends were pressed on where the brass spread out to hold the bracket on.  If the shaft is just a little loose, could try and put the shaft on a press to tighten it up.  If really loose, maybe epoxy, plus pressing.  Last resort is replace with another one.
Charles Turner
MCA/SAAC Judge

C Griffith

  • Newbie
  • *
  • Posts: 5
    • View Profile
Re: Autolite 4100
« Reply #2 on: July 22, 2021, 02:49:20 PM »
Thank you for your reply Charles.   Will see if I can press it on a little more.

Charles Griffith

Dan Case

  • Sr. Member
  • ****
  • Posts: 400
  • CSX2310
    • View Profile
Re: Autolite 4100
« Reply #3 on: July 22, 2021, 04:22:24 PM »
I made a tool out of an old cold chisel to tighten up the upsets on throttle shafts without flattening the factory radial ridges.


It is also possible to silver braze the lever to the shaft (shaft has to be out of the carburetor). It takes very little filler material to work. If you get the parts too hot the lever may need to be replated.
Dan Case
1964 Cobra owner since 1983, Cobra crazy since I saw my first one in the mid 1960s in Huntsville, AL.