News:

SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.

Main Menu

Front fended interior surface finish

Started by Corey Bowcutt, August 16, 2021, 08:19:34 AM

Previous topic - Next topic

Corey Bowcutt

I am trying to figure out how the inside surfaces of the front fender were finished leaving A. O. Smith.  These are some of my thoughts. 

The fenders I presume were painted off the car (at ford) because I know the screws are not painted? 

I presume the fenders were red oxide epoxy primed before body color was applied? 

From the pictures shown below that I pulled from thecoralsnake.com it appears the inside of the fenders were painted body color.

So were the insides in fact painted body color or was it red oxide with just body color overspray or...

Thank you,

Corey

66S285

In my opinion that color is not the original red oxide.
66S285

Coralsnake

Original fenders were red oxide with body color overspray on the backsides

Original inner aprons were usually bare steel with a blackout, the bottom surfaces of those aprons is typically unpainted or lightly painted.

The pictures you found have a liberal interpretation of both. (Thats the nice way of saying it could be better)
The original Influencer, check out www.thecoralsnake.com

Corey Bowcutt

Thank you Pete.  That is what I figured.

Corey

CharlesTurner

Looks like the pics are of a red or orange car?  Would be hard to see that color over-spray on red-oxide.

Agree about red-oxide on the inner fender panels up top... there is usually just black over bare metal up there...

Charles Turner
MCA/SAAC Judge