I currently have the clock out of my 70 Mach 1. I did a light spray with contact cleaner, used an emery board to lightly clean the points, and used clock oil to lube it very sparingly at the locations shown in the article. Unfortunately, the mechanical part still doesn't work. If I apply 12 volts the contacts will spread apart, but the clock doesn't run thereafter. If I apply pressure to the open points to close them, the mechanism runs. I don't see anything that looks broken or disconnected. At this point I'm considering converting to a quartz mechanism, but still frustrating. I had expected the problem to be the points or the solenoid.