News:

SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.

Main Menu

T10 rebuild kits?

Started by CharlesTurner, January 20, 2022, 02:33:03 PM

Previous topic - Next topic

CharlesTurner

Anyone have recommendations for a good T10 rebuild kit?  Needed for a standard '66 Mustang cast-iron T10.
Charles Turner
MCA/SAAC Judge

SFM6S


pmustang

I would chat with Randy. He advised me when I was having fits with a rebuilt T-10 popping out of gear

Then another one popping out of gear

He suggested Hooked sliders which solved the
Issue

gt350hr

  Charles ,
      As I'm sure you are aware the '66"only" T10 is different than '65 and earlier units. It's actually an early "super T10' and takes a different kit. The synchro assemblies and some of the bearings are different. The tag  or gear ratio numbers would tell . or the tooth count on the input.
    Randy
Celebrating 46 years of drag racing 6S477 and no end in sight.

shlby66



    Randy,
    What would be a correct, rebuild kit, for the 65, early 66, Aluminum T-10?  Since mine is currently out of
    the Shelby, I should go thru it, at this time. Thank you, for any information.

    Doug C. 

gt350hr

    Doug ,
       I don't know the actual number . I just go to my local dealer and buy kits as I need them. I can get you the parts you need any time.
  Randy
Celebrating 46 years of drag racing 6S477 and no end in sight.

shlby66




   Randy,
   You have a PM.
   Doug

gt350hr

    Thanks Doug , I 'll get one together for you.
Celebrating 46 years of drag racing 6S477 and no end in sight.

Iceman

dear people, is the rebuild kit of the cast iron case and the aluminum case the same?

gt350hr

   YES. You can buy a "generic" T-10 rebuild kit on line . I prefer to use some different items while still using some parts supplied in generic kits. Needle bearings , ball bearings , thrust washers , snap rings etc are all fine, but I select the brass and synchro assemblies I want to use. All parts are NOT the same in this case.
   Randy
Celebrating 46 years of drag racing 6S477 and no end in sight.

csxsfm

There are a few rebuild items (hubs, brass blocker rings, etc) you can get from Richmond Gear that maybe avoids the China concerns.  Or not.

gt350hr

   "To me" the only acceptable aftermarket brass for a T10 comes from Autogear.  I had a tiny part in the development if that fine product. Many replace brass that doesn't need to be trying to solve shifting issues caused by other components. Some of these issues can also accelerate brass wear so it's kind of a double edge sword.
Celebrating 46 years of drag racing 6S477 and no end in sight.