My original paint kr before restoration
Drivers fender cobra head center 1 1/8 down from bodyline
8 1/2 inches over from panel edge. Base of cobra 4 inches down. 9 3/8 over from fender edge.
428 is 5 1/2 inches from panel edge
When you say panel edge are you talking about the edge that forms the fender to door body gap? Also from what exact part of the emblem are the 8 1/2 , 9 3/8 and 5 1/2 measurements taken from?
Also what is base of cobra 4 inches down?
Appreciate the measurements just want to make sure I understand. Thanks!
Panel edge of the fender at the door gap, if you hook a tape measure on the fender going forward. This is the driver side.
8 1/2 to center of the snake head (from edge gap forward)
9 3/8 to the foward most part of the snake coil (from edge gap forward)
5 1/2 inches from fender edge to the right side of the 8 in 428 (from edge gap forward)
Base of cobra is 4" down from bodyline (top to bottom)
Head of cobra is 1 1/8 " down from bodyline (top to bottom)
The picture is from 1994. if you look closely you can see the marks at the measurements. Sorry the pics a little faded