News:

SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.

Main Menu

Vacuum schematics

Started by Thanx2cs, July 29, 2023, 09:55:38 PM

Previous topic - Next topic

Thanx2cs

Looking for vacuum schematics for my 68 GT500 w/automatic.  Where to look?

Thanks

Bob Gaines

Quote from: Thanx2cs on July 29, 2023, 09:55:38 PM
Looking for vacuum schematics for my 68 GT500 w/automatic.  Where to look?

Thanks
Major Mustang vendors like National Parts Depot sell a condensed version of the Mustang specific vacuum schematics.
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

Coralsnake

Are you looking for engine or everything?
The original Influencer, check out www.thecoralsnake.com

Thanx2cs

Yes,
I thought it was on your site CS.
Thanks

Thanx2cs

I realized I did not answer your question.

Yes to engine and everything. 

Coralsnake

I am going to assume you have the correct intake fittings, vacuum advance and vacuum tree on the thermostat housing:

Vacuum tree top port to carb is yellow stripe
Vacuum tree center port to distributor vacuum advance is green stripe
Vacuum tree  bottom port to front intake fitting is red stripe

Brake booster, vacuum modulator for trans and tilt steering are off rear intake fitting

Smog anti- backfire canister goes to front intake fitting (I think)

If you have AC you will need the diagrams

The original Influencer, check out www.thecoralsnake.com