News:

SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.

Main Menu

Rear Backing Plate Substitution

Started by SHELB66, September 11, 2019, 04:20:05 PM

Previous topic - Next topic

SHELB66

Does anyone know off hand which other 9" Ford backing plates are acceptable substitutes for the original KH units found on the '66 Shelbys?  Mine are useable but severely rusted as my car spent time on the East coast.  I'm actually doing a rear brake job now.  What fun!  I am not concerned about originality at this point as this car is strictly a driver.  Any help would be greatly appreciated.  Thanks much!

Craig R.
66 Hertz 6S1564
06 Hertz #446
64 Ranchero V8 4spd
02 Explorer Sport Trac

TLea

There are other correct backing plates that don't have the KH markings. Wagner, Bendix and I think even a Bosch.

SHELB66

Thanks, Tim!  I can get a nice set of '68 Fairlane/Torino plates at a good price.  Could I use those without issue?  Thanks!

Craig R.
66 Hertz 6S1564
06 Hertz #446
64 Ranchero V8 4spd
02 Explorer Sport Trac

TLea

As long as they are for 10x 2 1/2" brakes. I have both KH and Wagner here so I can get you engineering #'s if needed

JD

and you reuse your 2 1/2 inch sized shoe retainer pins.
'67 Shelby Headlight Bucket Grommets https://www.saacforum.com/index.php?topic=254.0
'67 Shelby Lower Grille Edge Protective Strip https://www.saacforum.com/index.php?topic=1237.0

SHELB66

^^^  Thanks!  I purchased all new, correct brake hardware, including the 2-1/2" pins, from Virginia Mustang.  I'm all set to go,  I just ordered new rear brake lines also as mine are in pretty bad shape with turned & rusty fittings.  Always something to slow down the job!

Craig R.
66 Hertz 6S1564
06 Hertz #446
64 Ranchero V8 4spd
02 Explorer Sport Trac