News:

SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.

Main Menu

68 GT500 sway bar end links

Started by KR Convertible, September 23, 2019, 01:27:50 PM

Previous topic - Next topic

KR Convertible

Took 68 #181 out for a drive yesterday and lost an end link.  I found some parts, but not everything.  Does anyone have a NOS one kicking around?  Is there a concours correct repro out there?  Thanks.

Bob Gaines

Quote from: KR Convertible on September 23, 2019, 01:27:50 PM
Took 68 #181 out for a drive yesterday and lost an end link.  I found some parts, but not everything.  Does anyone have a NOS one kicking around?  Is there a concours correct repro out there?  Thanks.
AMK sells one for 68. The makers marks are not correct on the ones I have seen but other then that it is fine . I reuse the original bolts. FYI nothing special on the 68 end link kit as it was the same as the regular Mustang. The NOS service kits I have had did not have the correct assemblyline makers marks on the heads of the bolts ether.
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

KR Convertible

I spoke to Jack at Dead Nuts On and he says these are correct for 68 as well as 69-70.  What do you think?

https://www.deadnutson.com/front-sway-bar-end-link-kit/

Bob Gaines

Quote from: KR Convertible on September 23, 2019, 05:35:08 PM
I spoke to Jack at Dead Nuts On and he says these are correct for 68 as well as 69-70.  What do you think?

https://www.deadnutson.com/front-sway-bar-end-link-kit/
I think those look good and are close to one of the different makers marks that I have seen.
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

KR Convertible

They look like what's on the car now.  Just wasn't sure if if they were correct.  Jack said he was going to update his website to include 68.  Thanks Bob