News:

SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.

Main Menu

GT500 1967 Exhaust Hangers and Motor Mounts for concours/ Survivour

Started by Kent, February 22, 2020, 06:08:13 AM

Previous topic - Next topic

Kent

Hello where do I find good repros of the GT500 exhaust hangers and Motor Mounts? Bob what are you using?
SAAC Member from Germany and Owner of a unrestored 1967 Shelby GT500, 1968 1/2 Cobra Jet´s and some nice Mustang Fastback´s 67/68

Coralsnake

The brackets can be sourced used, the insulators are around in nos. There is only one source for exhaust brackets in my opinion, unless you want true nos, thats Scott Fuller Reproductions.


For a survivor, you will want to souce original parts
The original Influencer, check out www.thecoralsnake.com

Special Ed

Are u wanting engine block frame brackets or the plates on the block?

Bob Gaines

Quote from: Coralsnake on February 22, 2020, 07:22:47 AM
The brackets can be sourced used, the insulators are around in nos. There is only one source for exhaust brackets in my opinion, unless you want true nos, thats Scott Fuller Reproductions.


For a survivor, you will want to souce original parts
What he said +1 :D
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

Kent

I´m looking for the engine rubber motor mounts. I bought a set "concours" for a mustang but they look like crap, holes wrong, rubber finish wrong, no part number.
SAAC Member from Germany and Owner of a unrestored 1967 Shelby GT500, 1968 1/2 Cobra Jet´s and some nice Mustang Fastback´s 67/68

Bob Gaines

FYI the originals did not have engineering numbers stamped into them anywhere and typically only one side had a Ford trademark. This is in reference to the exhaust hangers.
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

Special Ed

All the big block rubber mounts I got have ford eng# in the rubber and I got some c7za # mounts and I think fastback was an H or was that 68  but I know c7za-k is convertible big block.

Coralsnake

The 1968 insulators have engineering numbers molded on them. The ones you are most likely to see now are the D1ZZ service parts
The original Influencer, check out www.thecoralsnake.com

Special Ed

Just pulled a set of c7za-6038-d  FOMOCO  AU   marked   engine rubber mounts out of my motor mounts shelf inventory along with a set of c7za-k rubber mounts.

Kent

So there are no correct reproductions of the c7za rubber mounts?
SAAC Member from Germany and Owner of a unrestored 1967 Shelby GT500, 1968 1/2 Cobra Jet´s and some nice Mustang Fastback´s 67/68

Bob Gaines

Quote from: Kent on February 23, 2020, 08:31:09 AM
So there are no correct reproductions of the c7za rubber mounts?
No correct repros of the rubber motor mounts. Nice used originals in good shape are still a viable source for the time being.
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby